Battery Sizing
lift + cruise VTOL
Not saved
FTMS ↗
Configurations 0
Airframe
Battery packs
Mission phases
km/h
%
How phases work
Normal
Flown and consumed. Its energy counts against the mission.
Reserve
Energy that must still be in the pack at landing. It is budgeted, not flown, and is not checked for current.
Derived
Reuses another phase’s consumption times a factor, e.g. Descent = 0.6 × Hover. Pick the source under the name; the factor goes in the Vertical column.
A / W
A/m: average current per motor, as on a motor datasheet. ΣA: average current of all the motors of that lift system together, e.g. from a current sensor on its bus. W: average electrical power of all the motors of that lift system, e.g. from a flight log. All are averages over the phase, not totals of energy.
Peak
Switch the table to Peak to enter the highest current of each lift system in the phase (ΣA, e.g. read from an FTMS flight). It is only checked against the pack’s continuous and burst ratings; the energy always uses the average. 0 means not measured.
At V
The pack voltage the currents were measured at. Given, the phase is flown at the power it implies, so its current rises as the pack drains. Empty, it is flown at constant current. W phases are always flown at constant power.
Pack current
What the pack delivers during the phase, on average. Its highest value in the phase is compared with the pack’s continuous and burst ratings (C × capacity).
Energy
Drawn from the cells during the phase, resistive losses included, computed by the server. The mission may plan down to 20 % SoC.
SoC
State of charge at the end of the phase. Each pack starts at the Start SoC and drains phase by phase; the reserve is flown after the normal phases. Its voltage follows the battery’s discharge curve, set in the battery library.
State of charge
Energy and power per phase
Vertical Horizontal
Live analysis —
Current headroom
Checks 0

Battery Sizing

Sign in with your FTMS account to size battery configurations for lift+cruise VTOL aircraft.